Analog Way ASCENDER 16 (LIVECORE) - Ref. ASC1602 User Manual - Manual (Page 84)

84
7.4.8 Monitoring management
On the left side toolbar, you have access to your 8 still slots. Those slots can be filled by logos and frames. To
load the slots, go into the SETUP section and click on Logos menu. You can then assign an previously acquired
image from the Logo Library to each slot.
Or on the EDIT or LIVE pages section, under the logos tab, click on the Setup button next to each slot to
access to the slot configuration. Choose the logo from your library to fill the slot. Other logos configurations
are available. (See chapter: 7.3.12 Logo management)
On the left ribbon, inputs can be taken and drop on the layer. The inputs have been set on the Setup
part but a shortcut enables settings modification in the Edit section.
The active plug is chosen on the Setup section; but it can also be modified in the Edit and Live sections.
Warning: if you change the active plug while the input is displayed in a layer, you will change the source
displayed. You may see some artifact during switching.
The operators’ monitor layout is configured under EDIT/LIVE -> Monitoring. The layout can be in mosaic/
multiviewer mode with several windows/widgets, or fullscreen mode where only one window is displayed.
12 windows/widgets are available on all Livecore operator’s Monitoring outputs, with the exception of the
Nextage, which has only 8.
Several user-customizable predefined templates are available by clicking LOAD next to “Templates”. All
windows can be adjusted in size and position but cannot be overlapped.
The display on layout view enables a feedback of the number of resources used to display one widget.
Displaying a multi-stream source like a blended screen or dual-link input will limit the number of elements
that can be displayed.
7.4.6 Logos and Frames management
7.4.7 Inputs management
7.4.8 Monitoring management