Analog Way ASCENDER 16 (LIVECORE) - Ref. ASC1602 User Manual User Manual
Page 56

56
7.3.10 Input management
Under the OPTIMIZE section – only for analog signals, you have:
- AUTO CENTER:
Automatic search of the right Clock and Phase of your input. In other words, it automatically
search for the first and the last pixel of the signal. There are two modes: a quick search and an advanced
search typically launched when the source is rich in content such as a vertical burst. It is only available for
analog computer signals.
- CLOCK:
Set up manually the clock of your input
- PHASE:
Set up manually the phase of your input
Under the USER GAIN section, you find:
- THE RED/GREEN/BLUE:
Increase/decrease the Red/Green/Blue level of your input.
Under the SHARPNESS section, you have:
LEVEL:
Details level of the image, apply more or less image processing to make a better result when the
source is highly resized, it reduce the scaling artefacts.
Under the DEINTERLACER section – only for interlaced signals , you have:
- 2:2:
Enable/disable the 2:2 feature. Let it enable by default. The 2:2 is useful because it
launches a specific frame/line algorithm when 2:2 content is played.
- 3:2:
Enable/disable the 3:2 feature. Let it enable by default. The 3:2 is useful because it
launches a specific frame/line algorithm when 3:2 content is played.
Next you have the ASPECT tab. All settings about the blanking and aspect ratio are available there:
Under the BLANKING ADJUSTEMENTS – only for analog signals:
- H&V POSITION SIZE:
You can manually adjust the
input blanking with the V&H size or position.