Analog Way ASCENDER 16 (LIVECORE) - Ref. ASC1602 User Manual - Manual (Page 46)

46
7.3.2 Link section
Once the source is defined, a summary of your rate settings will be displayed under the tab STATUS.
WARNING: Configuring the rate to follow a framelock input will lock the output frame rate to match the
selected source. This is useful to eliminate the “strobing effect” which may be visible as an artifact of the
framelocking process. However, be sure that your framelock reference input is a reliable source, as any
disruptions in the reference signal may cause visible glitches on your output, even if the selected framelock
reference input is not currently being displayed.
The Outputs section defines if you will be using any of the outputs in Dual Link or 4k modes, or if you will be
reassigning the layer resources of one output to another. To activate a Dual Link output, drag the adjacent
resources onto output 1 or 3, then check the Dual Link option box.
Dual-Link resolutions (ie: 2560x1600) are only available on the DVI plug on outputs #1 & #3 as they use
resources from both outputs. You will lose the outputs #2 & #4 by activating the output #1 or #3 as a Dual-
Link output.
The link section is where the additive modularity is set. This feature is only available for 4U LiveCore™ units.
The device can be run in Single Device (standalone) or as a pair with another device by linking them. Use
the Guideline button in the upper right of the page to display a diagram of how to connect the two devices.
Please see chapter: 10. Assembling and devices coupling .
7.3.3 Outputs section
7.3.2 Link section