Analog Way ASCENDER 16 (LIVECORE) - Ref. ASC1602 User Manual - Manual (Page 13)

13
4.2 Unpacking and inspection
• 1 x LiveCore™ unit
• 1 x Power supply cord
• 1 x Ethernet cross cable (for device control)
• 1 x Web-based Remote Control Software included and hosted on the device
• 1 x Rack mount kit
• 1 x User manual (PDF version)*
• 1 x Quick start guide*
* User manual and Quick start guide are also available on www.analogway.com
Before racking and plugging any inputs and outputs, it is advised to power on the unit. Should you encounter
any issue, you must contact immediately your local distributor or dealer, or closest Analog Way technical
support offices (see chapter: 14. Contact information) .
Tabletop mounting: LiveCore™ unit can be used directly on a table; the unit is equipped with 4 handy anti-
slip rubber feet.
Rack mounting: LiveCore™ unit is compatible with a 19” enclosure. Please follow the instructions below to
install the device in a 19” rack.
CAUTION: a 4U LiveCore™ unit weighs 42.77LBS (19,4Kg) and 3U weighs 30.86LBS (14Kg). Please provide
appropriate support to the frame during installation. First, place ears on each side of the device (ref: 180469)
Place the device in your rack. Attach the device to the rack by using 2 screws through the ears (screws not
included).
Additional support, such as the rear rack support or slide rails, is required. LiveCore™ unit is equipped with
threaded holes designed for compatibility with a rear rack mount such as ref. 180489. Use the holes in the
rear support arm to adjust the length of the rear rack support arm in order to reach the rear rack rail when
installed in the rack. Use four M4x10mm screws in the countersunk holes in the rear support bar on both
sides of the unit.
A lacing bar is provided with the rack mount kit (ref: 180489). Install it with the M4x10 screws according to
your cables position.
Connect all of the cables to the device and attach them to the lacing bar with the help of tie wraps.
IMPORTANT:
- The openings in the front and rear panels of the device are for cooling. Air flows from front to back. Do not
cover these openings to avoid cutting air circulation.
- The maximum ambient operating temperature should not exceed 40°C (104°F).
- The rack and all mounted equipment in it must be reliably grounded according to national and/or local
electrical standards.
4.2 Unpacking and inspection
4.3 Rack mount information
CAUTION!
Mounting using only the front rack ears is sufficient for fixed installations. Additional support, such as the rear rack support or
slide rails, is required for mobile applications, and recommended for all.