AMETEK XG Family Programmable DC - Manual (Page 384)

APPENDIX E
Lantronix Procedures for MEA Option
E-14 M370430-01 Rev E
3. Enter the name of the connection and select the icon.
4. Click OK.
The new connection setup dialog box will appear (Figure E-16).
Figure E-16 New Connection Dialog Box
5. In the Connect using: box, select “TCP/IP (Winsock)”.
6. In the Host address box, enter the IP address, obtained in the
section entitled “Assigning an IP Address to the Power
Supply Unit” that starts on page E-8.
7. In the Port number box, enter “10001” as the value.
8. Click OK.
To specify the terminal connection properties:
1. Click Disconnect if necessary, and click Properties in the
main HyperTerminal window. See Figure E-17.