AMETEK XG Family Programmable DC - Manual (Page 266)

Calibration and Troubleshooting
7-2 M370430-01 Rev E
Introduction
The calibration of the power supply is software dependent, and
there are no potentiometers to adjust.
Calibration is performed via SCPI commands. The following items
need to be calibrated:
• Programmed voltage
• Voltage readback
• Programmed current
• Current readback
• Non-isolated voltage monitoring
• Isolated voltage monitoring
• Non-isolated current monitoring
• Isolated current monitoring
• Isolated source for analog programming
• Non-isolated source for analog programming
• Over voltage protection system
CAUTION: Equipment damage
Calibration procedures should only be performed by qualified user.