AMETEK XG Family Programmable DC - Manual (Page 382)

APPENDIX E
Lantronix Procedures for MEA Option
E-12 M370430-01 Rev E
3. Press the rotary Adjust/Enter control.
Α∆∆Ρ
is displayed on the output voltage display.
4. Turn the rotary Adjust/Enter control to select the desired
address between 1 to 30.
5. Press the rotary Adjust/Enter control to commit the new
address.
Terminal Configuration
The terminal program allows for communication with the power supply.
To use a terminal program, set it up using the parameters from the
following sections. If you wish to use HyperTerminal, see “Setting Up a
HyperTerminal Connection” below for instructions.
Data Format
Serial data format is 8 bit, one stop bit. No parity bit. Flow control:
none.
End of Message
The end of message is the Carriage Return character (ASCII 13,
0x0D).The power supply ignores the Line Feed (ASCII 10, 0x0A)
character.
Setting Up a HyperTerminal Connection
To set up a HyperTerminal connection:
1. Start Windows HyperTerminal by clicking Start >All
Program >Accessories > Communications > HyperTerminal.
The New Connection HyperTerminal window appears (Figure
E-14).