AMETEK XG Family Programmable DC - Manual (Page 219)

Communications Options
M370430-01 Rev E 6-13
6
characters and instrument SCPI commands for remote control.
The IANA registered Port number for the Instrument SCPI
interface is 5025.
TCP Remote port = 5025
The socket number can be changed on the power source using the
SYST:COMM:LAN:PORT command. Refer to the SYSTEM
COMMANDS section that follows.
Instrument Drivers and Application Software
Instrument drivers for National Instruments LabWindows/CVI and
LabView are generally available for download from the AMETEK
Programmable Power Web site at
www.programmablepower.com .
Also available are ready-to-use interactive graphical user interface
(GUI) programs for download.
AMETEK LXI DISCOVERY BROWSER
The AMETEK LXI Discovery Browser is a software tool provided
by AMETEK. This tool can be used to automatically locate LXI
compliant devices on your network. This is especially helpful if
any of them are using DHCP. In this case, the IP address of the
device is not known at power up since it is being automatically set
by the network’s DHCP server. The AMETEK LXI Discovery
Browser will scan the network and return the IP addresses of any
attached LXI compliant devices.
Installing the AMETEK LXI Discovery Browser
The software can be downloaded from the AMETEK
Programmable Power website.
1. Go to the folder for LXI Discovery Browser and ENet Test
Utility.
2. From there go to the EVXIBrowse directory.
3. Go to the Disk1 directory.
4. In the Disk1 select the Setup application. A window similar
to the following figure should appear.