Step 1: inspecting and cleaning – AMETEK XG Family Programmable DC User Manual
Page 33
Installation
M370430-01 Rev E
2-3
2
Step 1: Inspecting and Cleaning
Initial Inspection
When you first receive your unit, perform a physical check:
1.
Inspect the unit for any scratches and cracks, broken switches,
connectors or displays.
2.
Ensure that the packing box contains the 7.5 foot (2.5 m)
power cord (supplied with the XG 850 W model only).
3.
If you see external damage or suspect internal damage,
contact the carrier immediately.
Periodic Cleaning
The power supply only requires periodic cleaning, not routine servicing.
Whenever a unit is removed from operation, clean the metal surfaces
with naptha or an equivalent solvent, and clean the front panel with a
weak solution of soap and water. Use low-pressure compressed air to
blow dust from components on the printed circuit boards.