AMETEK SLD Series User Manual
Page 59
Sorensen SLD-Series DC Load
Remote Programming
M540075-01 Rev C
5-5
COMMAND SLD
DC
RETURN
MEASure:CURRent {?}{;
⎢NL}
• ###.####
MEASure:VOLTage {?}{;
⎢NL}
• ###.####
LIM:CURRent:{HIGH|LOW
}{SP}{NR2}{;|NL}
•
LIM:CURRent:{HIGH|LOW
}{?}{;|NL}
• ###.####
LIM:POWer:{HIGH|LOW
}{SP}{NR2}{;|NL}
•
LIM:POWer:{HIGH|LOW
}{?}{;|NL}
• ###.####
LIM:VOLTage:{HIGH|LOW
}{SP}{NR2}{;|NL}
•
LIM:VOLTage:{HIGH|LOW
}{?}{;|NL}
• ###.####
Table 5-6 Measure and Limit Commands
COMMAND SLD
DC
RETURN
GLOBal:[STATe:] PRESet{SP}{ON|OFF}{;|NL}
•
GLOBal:[STATe:] LOAD{SP}{ON|OFF}{;|NL}
•
GLOBal:[STATe:] MODE{SP}{ON|OFF}{;|NL}
•
GLOBal:[STATe:] SHORt{SP}{ON|OFF}{;|NL}
•
GLOBal:[STATe:] DYNamic{SP}{ON|OFF}{;|NL}
•
GLOBal:[STATe:] LEVEL{SP}{HIGH|LOW}{;|NL}
•
GLOBal:[STATe:] cc{SP}R2{;|NL}
•
GLOBal:MEASure:CURRent{?}{;|NL}
• ###.##
GLOBal:MEASure:VOLtage{?}{;|NL}
• ###.##
Table 5-7 Global Commands
REMARKS:
1. d : 0 - 9
2. GLOB : GLOBAL (ALL CHANNELS ACTIVE AT SAME TIME)
3. CURRENT ENGINEERING UNIT : A
4. VOLTAGE ENGINEERING UNIT : V
5. RESISTANCE ENGINEERING UNIT :
Ω
6. PERIOD ENGINEERING UNIT : mS
7. SLEW-RATE ENGINEERING UNIT : A/
μS
Note
: The RS-232 command set is the same as the GPIB command set.