AMETEK SLD Series - Manual (Page 58)

Remote Programming Sorensen SLD-Series DC Load
5-4 M540075-01 Rev C
STATE Command RETURN
[STATe:] LOAD{SP}{ON|OFF}{;|NL}
[STATe:] LOAD{?}{;|NL}
0=OFF, 1=ON
[STATe:] MODE{SP}{CC|CR|CV|CP}{;|NL}
[STATe:] MODE{?}{;|NL} 0=CC, 1=CR
2=CV, 3=CP
[STATe:] SHORt{SP}{ON|OFF}{;|NL}
[STATe:] SHORt{?}{;|NL} 0=OFF, 1=ON
[STATe:] PRESet{SP}{ON|OFF}{;|NL}
[STATe:] PRESe{?}{;|NL} 0=OFF, 1=ON
[STATe:] SENSe{SP}{ON|OFF}{;|NL}
[STATe:] SENSe{?}{;|NL} 0=OFF, 1=ON
[STATe:] LEVEl{SP}{HIG|LOW|AIB}{;|NL}
[STATe:] LEVEl{?}{;|NL} 0=LOW, 1=HIGH
[STATe:] RANGe?{;|NL}
1=AUTO,
2=FIXED RANGE II
[STATe:] DYNamic{SP}{ON|OFF}{;|NL}
[STATe:] DYNamic{?}{;|NL} 0=OFF, 1=ON
[STATe:] WATT{SP}{ON|OFF}{;|NL}
[STATe:] WATT{?}{;|NL} 0=OFF, 1=ON
[STATe:] CLEar{;|NL}
[STATe:] ERRor{?}{;|NL} Dddddddd
[STATe:] NG{?}{;|NL} 0=OK, 1=NG
[STATe:] PROTect{?}{;|NL} Dddddddd
Table 5-4 State Command Summary
COMMAND NOTE RETURN
[SYStem:] RECall{SP}{m[,n]}{;|NL} M=1~5 n=1~30
[SYStem:] STORe{SP}{m[,n]}{;|NL} M=1~5 n=1~30
[SYStem:] REMOTE{;|NL} Only RS232 cmd
[SYStem:] LOCAL{;|NL} Only RS232 cmd 0=:OFF, 1=:ON
[SYStem:] NAME{?}{;|NL} “ XXXXX＂
Table 5-5 System Commands - All Modules