2 input binding post and wire considerations, 1 plug connectors, Input binding post and wire considerations – AMETEK SLD Series User Manual

Page 26

Text mode
Original mode

Installation

Sorensen SLD-Series DC Load

2-4

M540075-01 Rev C

Figure 2-3 Single Bay, Dual Input Electronic Load Module Plug-in and Removal

Figure 2-4 Dual Bay Electronic Load Plug-in and Removal

2.2

Input Binding Post and Wire Considerations

There are five ways that binding posts (+, com and -) can connect the input wires to the
Electronic:

2.2.1 Plug

Connectors

This is the most popular way to connect the input of electronic load to the device under test.
It is recommended the load current be less than 20A in this connection since the current
rating of the plug is rated to 20A. The maximum wire gauge should be limited to AWG14.