AMETEK DLM 600W Series - Manual (Page 61)

DLM 600W Series
M362161-01 Rev J 4-3
4.3 REMOTE ANALOG INTERFACE
The REMOTE ANALOG INTERFACE provides a means to remotely control and monitor
the operation of the power supply. Refer to Figure 4-2 for an illustration of the
connector, and Table 4–2 for pinout information.
Figure 4-2. Remote Analog Interface Connector
4.3.1 REMOTE ANALOG INTERFACE Connector
The REMOTE ANALOG INTERFACE connector is a 25–position female
subminiature–D type.
Pin No. Function Pin No. Function
1 ANALOG–CONTROL Input 14 EXTERNAL–OFF Input (+)
2 EXTERNAL–OFF Return 15 Auxiliary 5 VDC Output (+)
3 OVP Programming Input 16
OVP Resistance
Programming Output
4 REMOTE–CONTROL Status Output 17
OVP Resistance
Programming Return
5 VOLTAGE–MODE Status Output 18 FAULT Status Output
6 Auxiliary 5 VDC Return 19 Voltage Monitor Output
7 Current Monitor Output 20
Voltage Resistance
Programming Return
8 Voltage/Current Monitor Return 21
Voltage Resistance
Programming Output
9 Voltage Programming Input 22
Current Resistance
Programming Output
10 Current Programming Input 23
Current Resistance
Programming Return
11 Not Used 24 LOCAL–LOCKOUT Input
12 V/I/OVP Programming Return 25 OVP Status Output
13 Not Used
Table 4–2. Remote Analog Interface Connector Pinout