AMETEK DLM 600W Series - Manual (Page 59)

M362161-01 Rev J 4-1
SECTION 4
ADVANCED OPERATION
4.1 Introduction
The DLM Series power supplies provide extended configuration and interface
capabilities to allow them to be adapted for special applications. The SETUP switch
allows selection of programming and monitor voltage ranges, remote sensing, or slave
mode of operation. The REMOTE ANALOG INTERFACE provides remote program-
mability and monitoring of the output voltage, current, and OVP, as well as digital I/O for
control and status annunciation.
4.2 SETUP Switch
The SETUP switch is accessible from the rear panel of the unit. Refer to Figure 4-1 for
an illustration showing switch positions and ON/OFF orientation, and Table 4–1 for the
functions of the switch positions. The factory default settings are all switch positions
OFF (down).
Figure 4-1. SETUP Switch