AMETEK DLM 600W Series - Manual (Page 25)

M362161-01 Rev J 2-1
SECTION 2
INSTALLATION
2.1 Introduction
The DLM Series power supply has been fully calibrated and tested prior to shipment;
the unit is ready for immediate use upon receipt. However, when first unpacked, the
unit should be inspected to ensure that no shipping damage has occurred.
2.2 Initial Inspection
Perform a visual inspection of the shipping container prior to accepting the package
from the carrier. If damage to the shipping container is evident, a description of that
damage should be noted on the carrier's receipt and signed by the carrier's driver.
Perform a visual inspection of the unit after it is removed from the shipping container.
Check for shipping damage such as dents, scratches, distortion of the enclosure, or
damaged controls. If external damage is evident, there may be internal damage as
well. Immediately contact the carrier and file a claim for concealed damage. In
addition, the shipping container and filler material should be saved for inspection.
Forward a report of the damage to the Service Department where a customer service
representative will provide instructions for repair or replacement of the unit.
2.3 Location Considerations
The power supplies are designed for rackmount and benchtop applications. As
shipped, the supplies are configured for benchtop use. Conversion for rack mounting,
simply requires removal of the four feet from the bottom of the chassis and adding the
rackmount kit.
Since the units are fan–cooled, they require adequate clearance at the air intake and
exhaust so that air flow is not impeded. The air intake is at the front and front sides,
while the air exhaust is at the rear panel and rear sides. The temperature of the
ambient air at the air intake should not exceed 50°C.