Drylam PRO-LAM PL1200-HP - Manual (Page 72)

72
Troubleshooting
Overview
Before any troubleshooting is made on the quality of the finished film, please confirm the following
1. The rollers are clean and do not have excessive adhesive deposits.
2. The film used is of the same type, manufacture, thickness and temperature range.
3. Allow the laminator to cool to room temperature with the rollers gapped and then reheat - this
will dissipate any cold or hot spots or rollers of unequal temperatures.
4. Make sure that the electrical circuit the laminator is connected to is of sufficient power and
dedicated - This will prevent fuses from blowing and breakers from tripping.
5. Quickly inspect the laminator and its components for obvious failures or any broken
components, i.e., Broken mandrel clips-loose or misaligned towers, functional idler rollers, ECT.
If the extent of your problem exceeds the documentation in this manual please find
our online troubleshooting available at: www.pro-lam.com
Available online will be the latest in laminating troubleshooting and repair issues along with additional
technical support on-line or via e-mail Or contact the dealer through whom this laminator was
purchased.
Common Errors
• Sliding idler in the down position or incorrectly fed film
• Rollers Left gapped
• Film on backward (adhesive on the rollers)
• Incorrect temperature
• Fans not used
• Too much mandrel film tension
• Film curled around machine and blocking inflow of cooling air
• Incorrect tower alignment