Drylam PRO-LAM PL1200-HP - Manual (Page 35)

35
Mandrel Clip
The following diagrams show the proper use of the mandrel clip for film wrapped with the adhesive out
only if a film is being used that is wrapped with the adhesive in you must reverse the cores for the clip to
grip
Take note of the direction of the mandrel clip in relation to the film path and that it would allow the film to slip
Though this is shown as incorrect, it is the correct film path (adhesive touching idler not roller) for adhesive in
IT IS IMPERATIVE THAT THE ADHESIVE SIDE OF THE FILM NEVER
TOUCH THE ROLLER
Take note of the direction of the mandrel clip in relation to the film path and that it would NOT allow the film to
slip This drawing is viewed from the right, it is assumed the adhesive is wrapped to the outside of the roll