Drylam PRO-LAM PL1200-HP - Manual (Page 25)

25
Laminator Assembly
Mandrel Towers
Typical tower configuration on the laminator is either, slitter towers, which include the slitter assemblies
attached to it, or our standard towers, which come with machines void of slitters.
Slitter Towers
If your laminator was supplied with slitters, it is typical that the tower will be already attached to the
machine and they simply need to be pivoted upright.
1. Position the laminator mandrel towers. Do this by grabbing both towers and at the same time,
turn them upright until the holes in the towers are aligned with the holes in the panels
2. Install two 5/16 x ½” long, hex head bolts one in each tower
3. Take note that on the right tower the bolt must be oriented so that the side of the bolt is parallel
to the side of the slitter-actuating handle (see diagram.). Do not over tighten bolt it is better that it
be looser rather than over tightened.
Correct
Notice both bolt and arm lay flush and parallel
Incorrect,
Notice tip on bolt is preventing arm from seating
4. Check that the ball plunger on the tower rests in its indent in the slitter handle
5. Tighten all remaining attaching hardware