Drylam PRO-LAM PL1200-HP - Manual (Page 18)

18
STAND
The stand is an optional item on certain models and may or may not have been included with the
purchase of your laminator.
Your laminator stand is shipped in one box it may require simple assembly. You should clear out
sufficient space to unpack the stand. Make sure this area will provide access to both sides as well as the
front and back of the stand.
The Packing material should be retained for transportation and shipping for warranty or service.
Shipped with the stand you will find the film supply mandrels for the laminator and possibly any
additional options as you ordered such as a release liner winder.
The hardware used to assemble the stand is packed separately and shipped with the laminator.
The Tools required for assembly are:
1. 1 – 3/16” Allen wrench
2. 1 – 7/16” combination wrench or ratchet
In the box, that the stand is shipped in are the following:
A. 1 - Right side frame, with or without towers attached
B. 1 - Left side frame,
with or without towers attached
C. 2 - Spreaders
D. 4 - Feet or caster wheels (as ordered)
Stand Unpacking
Unpacking the stand does not need to be addressed, as it is straightforward.
After the stand is unpacked, consolidate the packing materials and remove it from the assembly area.
If the mandrels are unpacked from their boxes be very careful, they have a sharp protrusion in
the center of the mandrel that can cut if handled carelessly.
Please retain the original packing in the event the laminator must be returned to your dealer for
warranty or service