Drylam PRO-LAM PL1200-HP - Manual (Page 58)

58
Board Stock / Mounting
Your series II laminator is capable of laminating and encapsulating a wide variety of materials up to ¼”
thick
When laminating board stock the roller pressure adjustment knobs must be fully relieved.
The speed at which board stock is laminated should be much slower to allow the laminator to heat the
board sufficiently.
Wide format printer paper may shrink when laminated depending on the type and moisture content this
may cause a wide variety of problems.
We recommend using either a heat sensitive board or an adhesive such as 3m-77 and applying the paper
to the board stock prior to lamination
.