Drylam PRO-LAM PL1200-HP - Manual (Page 28)

28
Laminator Setup
Plug the machine into its respective outlet; make sure that this outlet is dedicated or of sufficient rating
(no other electrical devices used at the same time on this circuit).
!!!THIS CIRCUIT MUST BE GROUNDED Never Operate The Laminator Without A Ground!!!
Refer to “ Electrical Requirements” on page 12.
To better familiarize yourself with your laminating rollers, review the chapter on roller care and
maintenance starting of page 65
Check and familiarize yourself with the following functions
A. Turn temperature control knob to the lowest setting
B. Activate Heat Switch--it will glow red and you will see the temperature of the roller indicated in
the digital readout widow on the left side of the machine.
C. Turn the temperature control knob to 200 degrees and allow the temperature to raise 10 or 20
degrees--then turn off the heat switch.
D. Turn the fan switch on. You will hear the fans run and you will feel air coming out of the fans
behind the deflector located behind the lower heat roller. Turn the fans off.
E. Turn the speed control knob fully counterclockwise and depress the rocker switch (up arrow or
forward). Then slowly rotate the control knob clockwise and the rollers will begin to rotate. Turn
control knob counter-clockwise and deactivate the switch.
F. Rotate the gap lever a couple times (located on right-hand side panel). One-half revolution gaps
the rollers and one-half revolution pressurizes the rollers.
G. Turn the heat switch back on and the temperature control to 50 degrees watch the laminator for a
minute or so and make sure that the laminator does not continue to heat with the temperature
turned down, if so immediately unplug the laminator and contact your dealer.
Always keep the rollers gapped when the laminator is not in use