beautypg.com

Regular maintenance – Drylam PRO-LAM PL1200-HP User Manual

Page 63

background image

63

Regular Maintenance

Before beginning a procedure, always read it thoroughly

Never remove any service panels from the machine without first disconnecting the electrical

supply.

Cleaning the Laminator


The surface areas of the machine should be periodically cleaned with a damp cloth and a mild detergent.
Do not spray any cleaning solution on or near the laminator as this may cause irreparable damage to the
rollers.

Roller cleaning


Removal of an adhesive build up on the rollers should be done during every film change
To clean the front rollers: Remove the film and mandrels, remove the feed tray, Heat the machine to
temperature and then using a rough cotton cloth, wipe the adhesive off the rollers leather gloves may be
needed as protection from the high heat. Most film adhesives are easily removed from the rollers,

Under no circumstances should any abrasive material be used to clean the rollers


To aid in cleaning the rollers isopropyl alcohol of 98% or better (or any roller wash designed for heated
silicone laminating rollers only) may be used to separate the adhesive from the rollers. After removing
the adhesive from the rollers, use isopropyl alcohol of 98% or better to remove any dust or remaining
adhesive from the rollers.

Use caution when using alcohol or any flammable solvent to clean the rollers

Always disconnect the laminator from the electrical supply before cleaning.

Rubbing pad compound


The only regular lubrication required on your laminator is the rubbing pad assembly.

The rubbing pad is located on the right hand side of your laminator, inside the panel on the swing arm
near the end of the top laminating roller it consists of a virgin felt pad saturated with a high temperature
lubricant

The lubricant used on this component is an unique high temperature electrical insulating grease that does
not harden it is recommended that this lubricant (rubbing pad compound) be purchased through your
dealer or through us directly

Rubbing Pad Compound: - - - PLS Part# M-2001


Application of this item should be made when the display temperature starts to fluctuate erratically

When the machine is opened for service the integrity of the rubbing pad and related components should
always be inspected

Rubbing Pad Ass - - - PLS Part# M-2002