Drylam PRO-LAM PL1200-HP - Manual (Page 22)

22
Stand Assembly Review
Normal Procedure For stand assembly is as follows
1. Position the parts for assembly, layout the parts in their respective locations on the floor
2. Identify left frame piece (has the smaller slot in the mandrel tower).
3. Position the frame so that the aluminum mandrel tower is toward the front and on the right side
(inside) of the stand frame (feet down).
4. Install a spreader into the lower holes (spreaders are not directional). Use a 3/16 Allen wrench,
do not tighten the screws all the way.
5. Install second spreader onto the left frame piece, in the upper holes
6. Install right frame piece to the spreaders, this should be positioned so that the aluminum mandrel
tower is forward facing and inward.
7. Place the stand upside down on a flat level surface, tighten all 8 Allen screws
8. Install any other optional items that may have been included with your laminator using the
instructions supplied, if necessary
9. Once the stand is setup make sure that it is sturdy and all screws are tight
The screw holes on the top of the stand for mounting the laminator are off center. This should be
of no concern; this must be this way for correct laminator alignment (the hole should be justified to
the right).
Please retain the original packing in the event the laminator must be returned to your
Dealer for warrant or service.