Drylam PRO-LAM PL1200-HP - Manual (Page 67)

67
Slitter Assembly Lubrication
The slitter assembly requires lubrication when any adjustment is difficult
Use a graphite – lithium high temperature grease
Lubricate all surfaces subject to friction - - Adjustment screws, slitter shaft, slitter knobs slitter blade
holders and pivot points
Do not lubricate the towers or actuating arm
Use grease sparingly
Adjustment knob
Do not remove the adjustment screw to lubricate, turn the screw out, lubricate, and then turn it in until
the screw is seen on the other side of the blade holding block. Lubricate the end that is sticking out and
turn the screw through its full travel several times. A small amount of grease build up next to the block
is normal, if excessive wipe most of it off
Shaft
If necessary remove the old grease with a solvent, remove any oxidation, burrs or foreign substance
from the shaft using scotch brite./
Apply a thin film of grease to the slitter shaft with a rag, make sure that a small amount of grease is also
in the slot.
Move the slitter assemblies through their travel on the shaft re-grease until smooth movement is felt.