Drylam PRO-LAM PL1200-HP - Manual (Page 15)

15
UNPACKING
Because the series II laminator is available in several different sizes and configurations, some of the
following steps may not be applicable to your specific shipment. However, it may be a good idea to read
over the following documentation to familiarize yourself with your machine and the technology
involved
Typical shipment of the series II laminator is as follows.
A. Your laminator was shipped as a tabletop model.
B. Your laminator was shipped with a stand and the stand requires minimal assembly
C. Your laminator was shipped separated from the stand and your stand does require assembly
Included with your shipment you should find the following possibly in multiple boxes
.
1. Your laminator
2. The laminator stand (optional)
3. One set (2) of film supply roll mandrels
4. Mandrel
Towers
5. Feed Table
6. Control Handle
7. Slitter assembly (Optional)
8. Release Liner Winder (Optional)
9. Hardware kit
10. Your operators manual
The following pages address each component of your installation individually.
And is outlined as follows
1. Unpack the laminator
2. Unpack the stand
3. Assemble the stand
4. Install stand towers
5. Assemble the laminator