Drylam PRO-LAM PL1200-HP - Manual (Page 16)

16
LAMINATOR UNPACKING
Your laminator is shipped in one box. Some minor assembly is required. You should clear out sufficient
space to unpack the laminator. Make sure this area will provide access to both sides of the laminator as
well as the front and back of the machine.
The laminator is packed in specially designed material for shipping your laminator safely The Packing
material should be retained for transportation or for shipping in the event of a warranty or service issue.
In the box with the laminator you should find the feed tray and enclosed hardware the supply mandrels
will be shipped with the stand if the machine was purchased without a stand the mandrels should be
included with your shipment however in a different box.
!!! SEE THE NEXT PAGE FOR LIFT POINTS ON THE SERIES II LAMINATOR !!!
LAMINATOR REMOVAL
1. Remove the feed tray
2. Remove the center piece of foam
3. Using at least two people pull the laminator and remaining packing, by the lift points, from the
box. Use great care, the laminator may be quite heavy, dropping it will damage it.
4. Set the laminator on the floor and lift one end at a time and remove the foam shipping caps
5. Remove the remaining packing
6. Set the laminator aside and clear sufficient space for the stand and its packing
Please retain original packing in the event that the laminator must be moved or returned to your
dealer for warranty or service.
Use a sufficient number of people to remove the laminator from the box as the machine may weigh
in excess of 200 pounds.