Drylam PRO-LAM PL1200-HP - Manual (Page 11)

11
IF THE SLITTERS (SIDE TRIM KNIVES) ARE USED, USE EXTREME CAUTION
WHEN HANDLING THE KNIFE BLADES OR MAKING ADJUSTMENTS, AS THE
KNIFE BLADES ARE RAZOR SHARP.
USE MULTIPLE PEOPLE TO UNPACK AND MOVE THE LAMINATOR AS IT
WEIGHS IN EXCESS OF 75 POUNDS.
LEAVE REPAIRS AND MAINTENANCE TO A QUALIFIED PERSONNEL.
NEVER LEAVE THE MACHINE UNATTENDED WHILE IN USE.
SHUT THE MACHINE DOWN AND ALWAYS KEEP ROLLERS GAPPED WHILE
THE MACHINE IS NOT BEING ATTENDED GAPPING GREATLY EXTENDS THE
LIFE OF THE ROLLERS AS WELL AS SAVING $ IN LOST ENERGY. REMEMBER
YOUR NEW LAMINATOR TAKES AS FEW AS 4 TO 5 MINUTES TO WARM UP
RATHER THAN 20 OR 30
DO NOT ALLOW THE ROLLERS TO EXCEED 300 DEGREES DOING THIS
WILL GREATLY INCREASE THE LIFE OF THE LAMINATING ROLLERS –
THOUGH YOUR MACHINE IS PERFECTLY CAPABLE OF RUNNING FILM
RATED AT 300 DEGREES PRO-LAM RECOMENDS USING A FILM THAT IS
RATED AT A LOWER TEMPERATURE - THIS WILL INCREASE YOUR ROLLER
LIFE
DO NOT ADVANCE THE FILM THROUGH THE LAMINATOR WHILE
THE ROLLERS ARE COLD THIS MAY RESULT IN THE SURFACE BEING
TORN FROM THE ROLLERS BY THE AGGRESSIVE LAMINATING FILM
ADHESIVE.
DO NOT PLACE THE LAMINATOR NEAR ANY VENTILATION
SYSTEM AS THIS MAY COOL THE ROLLERS.
USE CARE WHEN CHANGING THE LAMINATING FILM AS THE FILM ROLLS
ARE VERY HEAVY AND MAY REQUIRE AS MANY AS 3 OR MORE PEOPLE TO
LOAD THE SUPPLY ROLLS ALSO USE CAUTION TO AVOID PINCHING HANDS
OR FINGERS WHILE LOADING THE ROLL