Vortech 2005-2008 Ford 4.0L V6 Mustang User Manual

Page 39

P/N: 4FU020-610

06AUG08 v4.1 05MusV6(4FU..610v4.1)

Fig. 11-a

11. REFLASH COMPUTER

A. Reconnect the battery.

B. Locate the vehicles OBD2 connector located

in the lower left hand corner of the dash on the

driver’s side of the vehicle. (See Fig 11-a.)

C. Attach the OBD2 connector from the Flash

tool that is provided in the kit to the vehicle’s

OBD2 port. (See Fig 15-b.) Make sure this

connector is seated all the way in the vehi-

cles OBD2 port. You do not want this connec-

tor coming out during programming or dam-

age may occur to the vehicle’s ECM.

D. The Reflash tool should power up and display

three parameters.

1. Performance Tune

2. Diagnostics

3. Options

E. Select “Performance Tune” and press the

enter button in the middle of the arrow keys.

(See Fig 11-c.)

F. Read the disclaimer entirely, then select

“Agree” and press enter.

G. At this point please read the screen displayed

on the reflash tool. If you have any questions,

either refer to the manual that is provided

with the reflash tool or contact our service

department for further assistance.

H. Turn the ignition on (do not start the vehicle).

Set the parking brake and press the enter

button to continue.

SELECT TUNE will be displayed at the top of

the screen. Use the arrow keys to select the

appropriate tune for your vehicle and press

the enter button. You will have a choice of

three to choose from:

1. STD OUTPUT (non charge-cooled)

2. CHARGE-COOLED, air/water

3. Original Backup

J. Continue to follow the screen instructions and

when finished unplug the reflash tool from the

vehicles OBD2 port.

IMPORTANT! To ensure trouble-free programming of your vehicle's computer:

• Make sure the vehicle's battery is sufficiently charged.

• Turn off all accessories and close doors to prevent unnecessary drain on the battery.

• Do not attempt to program your vehicle while a battery charger is connected.

• Improper battery voltage will result in failure of the programming process.

• Do not disconnect the cable or turn off the ignition during programming.

NOTE: Do not disturb the cable, or turn the

ignition off during this time. If the pro-

gramming is disrupted, the vehicle’s

computer may be damaged!

Fig. 11-b

Fig. 11-c

ARROWKEYS

ESCAPE

ENTER

SELECT