Vortech 2005-2008 Ford 4.0L V6 Mustang User Manual

Page 11

P/N: 4FU020-610

06AUG08 v4.1 05MusV6(4FU..610v4.1)

A. Disconnect the mass air flow (MAF) sensor

plug. Remove the MAF sensor from the facto-

ry inlet duct and set it aside (with the original

screws) for later use. (See Fig. 1-a.)

B. Disconnect the crankcase vent line where it

attaches to the driver’s side valve cover.

C. Remove the factory air filter housing and inlet

duct up to the throttle body. (See Fig. 1-a.)

D. Drain and remove the power steering reser-

voir. The reservoir will be relocated during a

later step.

E. Remove one of the three bolts from the

power steering pulley. Replace it with one of

the supplied M8-16mm bolts. (Do not use a

washer.) Repeat step for the two remaining

power steering pulley bolts. (See Fig. 1-b.)

F. Using a 3/8" ratchet, compress the accessory

belt spring tensioner and remove the belt

from the vehicle.

1. PREPARATION/REMOVAL

Fig. 1-a

Fig. 1-b

AIR

FILTER

HOUSING

CRANKCASE VENT

LINE

MAF

SENSOR

REPLACE

BOLTS