Vortech 2005-2008 Ford 4.0L V6 Mustang - Manual (Page 20)

P/N: 4FU020-610
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
06AUG08 v4.1 05MusV6(4FU..610v4.1)
10
7. CHARGE AIR COOLER INSTALLATION (H.O. KITS ONLY) , cont’d
NOTE: Leave these screws loose for
adjustment when attaching the
assembly to the vehicle.
NOTE: Refer to Fig. 7C-d throughout
the following steps:
1. Locate the water cooler assembly 8N106-
135.
2. Install the two mounting bracket 8N010-
171 and 8N010-173 to the water cooler
using the supplied 1/4-20 x 1/2" screws,
washers. (See Fig. 7B-a.)
3. Remove four nylon push pins from the
styrofoam bumper support and set the
support and the pins aside to be rein-
stalled. (See Fig. 7B-b.)
4. Remove six of the eight 13mm headed
inset bolts retaining the metal bumper
support. (See Fig. 7B-c.)
5. Replace the bolts previously removed
with the six 8mm x 1.25" x 35mm long
bolts and washers provided.
6. Install the four 2A017-036 spacers (two
each side) onto the bolts that will secure
the water cooler. (See Fig. 7B-d.)
B. WATER COOLER ASSEMBLY
INSTALLATION
NYLON PUSH
PINS
13mm HEADED
BOLTS
Fig. 7B-d
Fig. 7B-c
Fig. 7B-b
Fig. 7B-a
SPACERS
PROVIDED