Vortech 2005-2008 Ford 4.0L V6 Mustang - Manual (Page 35)

P/N: 4FU020-610
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
06AUG08 v4.1 05MusV6(4FU..610v4.1)
25
1"ID HOSE CONNECTION
ON SUPERCHARGER
DISCHARGE ELBOW
15" x 1" HOSE Ø
(TRIM TO FIT)
TO MANIFOLD PRESSURE/VACUUM
#16 HOSE CLAMPS
BYPASS
VALVE
TO INLET
DUCT
~6" X 1"
HOSE
Ø
8. STANDARD DISCHARGE, (Non-Cooled Kits Only)
A. Install the supplied supercharger elbow
between the supercharger discharge and the
throttle body. Secure with clamps. (See Fig.
8-a.)
B. Attach the bypass valve inlet to the discharge
elbow.
C. Attach one end of the supplied Ø1" hose to
the bypass valve discharge. Install and tight-
en the supplied #16 hose clamps on each
end of the bypass valve. The open end of the
hose will be connected to the air inlet in a
future step. (See Fig. 8-c)
D. Attach a length of 5/32" vacuum hose to the
bypass valve and route to the vacuum port
on top of the intake manifold. (See Fig. 8-c)
E. Remove the plastic union connecting the fuel
rail pressure sensor to the intake manifold.
Install the supplied TEE in its place. (See
Fig. 8-b.)
F. Attach the vacuum hose from the bypass
valve to the TEE.
Fig. 8-c
Fig. 8-a
Fig. 8-b