Vortech 2005-2008 Ford 4.0L V6 Mustang User Manual

Page 13

P/N: 4FU020-610

06AUG08 v4.1 05MusV6(4FU..610v4.1)

A. Locate the factory oil sensor on the driver’s

side near the front of the engine above the oil

pan.

B. Remove the sending unit and set aside.

C. Using engine oil on the threads, install the

supplied fittings in the following order.
1. Install the 1/4"NPT x 1.5" nipple into the

branch of the 1/4"NPT TEE.

2. Screw the open end of the 1/4"NPT nip-

ple into the engine block, where the pres-

sure sender was previously removed.

(See Fig. 3-a.)

3. Install the 1/4"NPT x 90° x -4 fitting and

factory oil pressure sender into the previ-

ously installed TEE. (See Fig. 3-a.)

Reconnect the pressure sender harness

connection.

D. Attach the stainless steel -4 hose to the -4 fit-

ting installed in the TEE.

E. Cover the open end and route the hose away

from hot, sharp or moving parts and to the

top of the engine to be attached to the super-

charger oil feed.

Fig. 3-a

NOTE: Pipe tape, paste or other sealant is

not recommended as it may loosen

and cause blockage of the oil feed

orifice, resulting in supercharger fail-

ure.

3. OIL FEED INSTALLATION (Engine oil-fed kits only. Applications with

V-3 superchargers skip ahead to step 4.)

1/4"NPT

NIPPLE

FACTORY

PRESSURE SENDER

1/4"NPT 90° -4

1/4"NPT

TEE