Deleting an array – StorCase Technology FC-to-SCSI Single & Dual RAID User Manual

Page 68

FC-SCSI Dual RAID Module User's Guide - Rev. A01

StorCase Technology, Inc.

Configuration

Press Esc twice to return to the System Menu.

Select Array Menu from the System Menu and press Enter.
The Select Array screen should now display, along with a list of existing arrays (Figure

19).

Select the desired array and press Enter.
The Array Menu should now display (Figure 20).

Select Trust Array and press Enter.
The system will now confirm your request to trust the array.

Select Yes and press Enter.

NOTE:

If the array does not come back online, it may be because there are too many members

offline. Or, it may be because the array may have additional failures on the bus (or

enclosure) that the Trust Array option cannot fix.

Deleting an Array

This function allows the user to delete an array when the array is no longer needed or when

the drives are needed for another use.

CAUTION:

Deleting an array will delete all partitions and data stored in that array!

Before reusing the drives, performing a low-level format on each drive is

recommended.

NOTE:

An array cannot be deleted while any utility (Initialize, Verify, Expand, or Reconstruct)

is running on the array. The utility must be stopped (if possible) or completed before

the array can be deleted.

To delete an array:

Select Delete an Array from the System Menu and press Enter.
The Select Array screen should now display (Figure 19).

Select the array to be deleted and press Enter.
The system will now confirm your request to delete the array.

Select Yes and press Enter.