StorCase Technology FC-to-SCSI Single & Dual RAID - Manual (Page 36)

FC-SCSI Dual RAID Module User's Guide - Rev. A01 StorCase Technology, Inc.
Configuration 23
InfoStation Serial Port Set-Up
To access the Administrator Utility via the UI Module RS-232 serial port, the user must first
configure the Serial Port Set-Up in the UI Module (see below).
Refer to the InfoStation User's Guide (specifically, sections "InfoStation User Interface" and
"Serial Port Set-Up") for further information.
NOTES:
Press CANCEL at anytime to exit the menu system and return to the Default
Display. The menu system will automatically cancel after 15 seconds of
User inactivity.
Factory default is S.Port0.
The following lists each InfoStation serial port option and its description.
S.Port0 = InfoMon monitoring via the UI Module Serial Port (refer to the InfoMon User's
Guide for further information).
S.Port1 = RAID configuration through the Primary RAID Controller Module via the
UI Module Serial Port.
S.Port2 = RAID configuration through the Secondary RAID Controller Module via the
UI Module Serial Port.
1. Press ENTER at the Default Display so that
display = Status.
2. Press DOWN until display = Setup.
3. Press ENTER so that display = Enc. ID.
4. Press DOWN until display = Ser.Port
5. Press ENTER so that display = S-Portx .
This is the current serial port set-up.
6. Press UP or DOWN to change the serial port
option.
7. Press ENTER to accept the change.
ENTER
S t a t u s
S e t u p
T E M P : x x C
E n c . I D
ENTER
DOWN
ENTER
DOWN
S e r . P o r t
S - P o r t = 0
UP/DOWN
ENTER
S - P o r t = 1
S - P o r t = 1