Blinking a drive led – StorCase Technology FC-to-SCSI Single & Dual RAID User Manual
Page 143
130
Configuration
StorCase Technology, Inc.
FC-SCSI Dual RAID Module User's Guide - Rev. A01
4.
Select the desired option and press Enter.
5.
Reboot or rescan to make any changes take effect (refer to sections "Rebooting the
Controller" and/or "Rescanning All Channels" for further information).
Blinking a Drive LED
This function allows the user to blink the LED on a specific drive.
To blink a drive LED:
1.
Select Utilities Menu from the System Menu and press Enter.
The Utilities Menu should now display (Figure 45).
2.
Select Drive Utilities Menu and press Enter.
The Drive Utilities Menu should now display (Figure 75).
3.
Select Blink Drive LED and press Enter.
The Select Drive screen should now display.
4.
Select the desired drive and press Enter.
The drive continues blinking its LED until the user does one of the following:
Press Esc before the Disk Array Administrator Utility times out.
Repeat the blink LED command, which toggles the blink LED command off.
5.
Press Esc to stop blinking the LED.