StorCase Technology FC-to-SCSI Single & Dual RAID User Manual

Page 107

Configuration

StorCase Technology, Inc.

FC-SCSI Dual RAID Module User's Guide - Rev. A01

Table 7: Host Channel Settings (cont'd)

To configure the host channels:

Select Configuration Menu from the System Menu and press Enter.
The Configuration Menu should now display (Figure 31).

Select Host Configuration and press Enter.
The Channel screen should now display.

Host Channel

Setting

Available

Modes

Description

Controller LUN

All

The controller has just one LUN that the user can change when

configuring the host channels. The user only needs to assign

a controller LUN if using the Configuration Application Program

Interface (CAPI) to configure the controller over a host channel

via SCSI protocol extensions.

If not using CAPI, the user can set the controller LUN to NONE.

If using CAPI, the user can set the controller LUN from 0-63.

Two options for setting the LUN:

NONE: Use this setting if not using CAPI to configure the con-

troller (change takes effect immediately unless the controller

LUN is currently in use).

Any number between 0-63: Select a specific number if the con-

troller LUN is to remain the same during reboot.

Refer to section

Understanding

LUNs and Viewing

LUN Information

for further informa-

tion.

IFSII_FDR20

Link Speed *

All

The speed can be set to either: 1GB or 2GB (factory default).

In a dual controller configuration (Active-Active or Active-

Passive mode), a change to this setting on either controller is

automatically updated on the other controller.

* NOTES:

HSSDC2 (copper) SFP modules support 1Gbps operation only.
LC (optical) SFP modules support both 2Gbps and 1Gbps operation.
The RAID Controller Module is factory set to 2Gbps.

Fibre Channel speed must also be set in InfoStation UI Module and FC HBA (refer to section

"InfoStation Fibre Channel Speed Set-Up" and FC HBA documentation for further information).