Changing the additional saf-te board settings – StorCase Technology FC-to-SCSI Single & Dual RAID User Manual

Page 148

FC-SCSI Dual RAID Module User's Guide - Rev. A01

StorCase Technology, Inc.

Configuration

135

Changing the Additional SAF-TE Board Settings

The user can change four (4) additional settings:

Polling Interval - The interval (in seconds) that the controller polls the SAF-TE Board

for status changes (default is 5 seconds).

Temperature Sensor Status - This controls whether the controller's onboard

temperature sensor provides temperature information to the host along with the en-

closure's temperature detected by the SAF-TE Board. Default is OFF (neither the

controller nor the enclosure is providing temperature information to the host).

Slot Update Status (Slot Flags) - This controls whether the controller sends com-

mands to the SAF-TE Board to upbeat the status of each enclosure drive bay. Default

is ON (controller will request status updates from the enclosure).

Enclosure Update Status (Global Flags)- This controls whether the controller

will send commands to the SAF-TE Board to update the overall status of the enclo-

sure. Default setting is OFF (controller will not request status updates from the

enclosure).

To change the SEP Settings:

Select Configuration Menu from the System Menu and press Enter.
The Configuration Menu should now display (Figure 31).

Select SEP Configuration and press Enter.
The SEP Configuration screen should now display (Figure 80).

Select SEP Settings and press Enter.
The Poll Rate screen should now display (Figure 83).

The system will confirm your request to change the LUN.

Select Yes and press Enter.

Do This

Not assign the

SEP a LUN

Keep the same LUN

for the SEP at all times

Select NONE and

press Enter.

Select the [LUN] you want

to use and press Enter.

This can be any number 0-63 that

is not already in use.

IFSII_FDR22