Martin Christ RVC 2-33 CDplus - Manual (Page 42)

RVC 2-33 CD &
Using the RVC
42 Version 01/2009, Rev. 1.21 of 25/11/2013 - sb
Translation of the original operating manual
Creating a new program
A new program can be created based on a fixed program template
and adapted to specific needs by changing the set values and by
adding and deleting certain sections. The control system
automatically assigns a program number to every new program.
To create a new program:
Select "New program" from the menu "Program administration"
(see fig. 6.18) and confirm. The following message will appear:
Fig. 6.20: Message "New program created"
Press the right-hand function key to confirm.
Continue as described under "Editing a program" (see below).
Editing a program
In order to edit a program, it must be selected from the program list:
Select "Edit program" from the menu "Program administration"
(see fig. 6.18) and confirm. The program list is shown.
Fig. 6.21: Program list
To edit a program:
Select a program from the program list.It will be opened for
editing. The program name and the section of the program can
be edited.
Fig.6.22: Editing a program
Open the menu "Program parameter" in order to change the
program name. Use the functions keys to position the focus in
the program name. Use the up/down keys to change the
character at the current focus position.
At the last position of the program name, the right-hand key
function changes to "ok" to enter the program name.