LINK Systems OmniLink 5000 - Manual (Page 93)

7.1
Section 7 Installation
Section 7.1 Component Mounting
The Operator Terminal must be mounted in a position that is easily seen and accessed by the operator.
The liquid crystal display is designed to be viewed from the bottom of the display. If the operator terminal
is mounted in a vertical plane, it must be mounted slightly above the operator's eye level. If mounted on
a sloped surface, it should be mounted so that the operator's line of sight is from the bottom of the LCD.
The desirable orientations are shown in Figure 7.1.
Figure 7.1 LCD Mounting Orientations
The required cutout dimensions for the operator terminal are shown in Figure 7.2.
Figure 7.2 Operator Terminal Mounting Dimensions