LINK Systems OmniLink 5000 - Manual (Page 15)

3.4
19 PLC Screen 1 Sets Change parameters on Screen 1 of the Programmable
Logic Controller Interface
20 PLC Screen 2 Sets Change parameters on Screen 2 of the Programmable
Logic Controller Interface
21 PLC Screen 3 Sets Change parameters on Screen 3 of the Programmable
Logic Controller Interface
22 PLC Screen 4 Sets Change parameters on Screen 4 of the Programmable
Logic Controller Interface
23 Special Interface Change parameters on the Special Interface Screen
24 Auto SS/COD Time Change the Automatic Single Stroke maximum time
between strokes, the Continuous on Demand maximum
time between Run cycles, and the Feed Complete Angle
25 Reset Brake Monitor Reset Brake Monitor faults
26 Motor Speed Adjust Adjust motor speed
27 Store Jobs Store jobs in memory, edit Machine Notes and Job
Notes
28 Recall Jobs Recall jobs from memory
29 Erase Jobs Erase jobs in memory
30 Reserved for future use
31 Reserved for future use
32 Reserved for future use
Section 3.3 Access Control Operation
To gain access control the user must use one of two means or a combination of these two means. These
means are the Program/Run key or the user password system.
Section 3.3.1 Program/Run Key Switch Operation
The Program/Run key switch is located on the lower right side of the operator terminal. This is a two
position switch. The key is removable in the RUN position only. If the Program/Run key switch is being
used as a means to access the restricted items, the switch must be turned to the PROG position. When the
Program/Run key switch is switched to the PROG position, the press will Top Stop and stroking will be
prohibited until the switch is returned to the RUN position.
When operating in the Key Only mode the key switch is the only means available to access the restricted