LINK Systems OmniLink 5000 - Manual (Page 46)

4.28
Stroke
Mode Single Stroke
Drive
Speed
Stroke
Speed
SPM
SPM
200
0
Order
Counter
PC STATUS
Counter OFF
QUICK
ACCESS
EDIT
NOTES
0 0
Ready to Stroke
TOP
EXIT
MACHINE NOTES
NOTES FOR JOB # 1
CURRENT LOGIN IN: OPERATOR # 1
AUXILIARY
COMM.
LOGOUT
Press lube should be type xyz. Check level daily
Flywheel belt deflection should be not more that 1” at midpoint.
Use material lube abc for this part
Material should have a maximum thickness of .161
1
2
3
Figure 4.17 Quick Access Screen
This display provides the following information:
1. The name of the current user who has access control. If the user logged in using a password.
2. Machine notes. These are notes that pertain to the machine.
3. Job notes. These are notes that pertain to the job. These notes will be saved and recalled with the
job setup.
Section 4.8.1 Machine Notes
The Machine Notes area allows information concerning the machine to be entered and displayed. This
information in not change as the current job is changed. This area allows for eight lines of text with each line
containing up to 59 characters.
Section 4.8.2 Job Notes
The Job Notes area allows information concerning the job to be entered and displayed. This information is
stored and recalled with the other job related information. This area allows for eight lines of text with each
line containing up to 59 characters.
Section 4.8.3 Editing Machine Notes and Job Notes
The machine notes and job notes can be changed by first selecting the EDIT NOTES softkey. The user must
have access control to edit these notes. Access control is described in Section 3. If the user obtains access
control by using the password system, the user must be configured to have access to store jobs. Position the
cursor to the line that is to be changed. Select the CHANGE TEXT softkey. The text edit box will appear
and the line can be edited. Press the ENT key to save the text on the line. If another line is to be edited,
position the cursor to that line and repeat the steps above. The arrow keys will move the cursor for the
Machine Notes box to the Job Notes box.