LINK Systems OmniLink 5000 - Manual (Page 14)

3.3
Section 3.2 Restricted Items
The following table lists the restricted items name and function.
RESTRICTED ITEMS
NUMBER NAME FUNCTION
1 PLS Bypass Bypass Programmable Limit Switch outputs
2 PLS Settings/Names Change Programmable Limit Switch setpoints and
names
3 TM Bypass Bypass the Tonnage Monitor
4 TM Reset Reset the Tonnage Monitor
5 TM Peak High Limits Change the Tonnage Monitor high limits
6 TM Peak Low Limits Change the Tonnage Monitor low limits
7 TM Peak Reverse Limits Change the Tonnage Monitor reverse limits
8 TM Auto Setup Perform a Tonnage Monitor automatic limit setup
9 TM Data Windows Change the Tonnage Monitor data window angles and
limits
10 DP Bypass Bypass the Die Protection
11 DP Reset Reset the Die Protection
12 DP Settings Change the Die Protection settings
13 Auto Setup Reset Reset automatic air adjust and shut height adjust faults
14 Auto Setup Settings Change the automatic air adjust and shut height adjust
settings
15 Counter Reset Reset counters that have reached their limit
16 Counter Settings Change counter limits. Turn counters off and on
17 Counter Change Change the current counter value. Increase current
count value by one (Increment). Decrease current
count value by one (Decrement). Increase scrap count
by one (Increment Scrap). Decrease scrap count by one
(Decrement Scrap).
18 Feed Settings Change feed settings