Datamax PE - Manual (Page 47)

PE Series Operator’s Manual 37
Pqfsbujpo
(CONT.)
Test Mode Causes the printer to send debug characters back to
the host. See Appendix E for listings.
*Disable
Enable
Cutter Controls an external cutter mechanism.
Enable Enables an external cutter.
*Disable Cutter not being used.
Ribbon Saver Controls the optional Ribbon Saver feature.
Enable Enables the option.
*Disable Option is not installed or disabled.
Conversion Sets standard or metric measurement, automatically
updating all operations with the new selection.
*Decimal Measurements in inches
Metric Measurements in millimeters
Dpnnvojdbujpot
Allows the user to select communication values for
each port.
Comm Setup Selects the port and sets parameters.
*PORTA *9600 Selects serial Port A, B or Parallel communication.
*8 *N *1 *BOTH Selectable serial baud rates: 300, 600, 1200, 2400,
4800, 9600, 19200.
Sets word length: 7 or 8 bits.
Sets parity bit: E = even, O = odd, N = none.
Sets stop bit length: 1 or 2 bits.
Selects handshaking method: XON/XOFF,
CTS/DTR or BOTH.
Control Codes Sets the DPL control code values.
*Standard Codes 01 Hex = SOH command, 02 Hex = STX command
Alternate Codes 5E Hex = SOH command, 7E Hex = STX command