Datamax PE - Manual (Page 23)

PE Series Operator’s Manual 13
3.3 Loading Ribbon (Thermal Transfer)
The printer can use two methods to create an image on the media.
The first method, called direct thermal, uses specially treated label
stock containing dyes that turn black with heat and pressure.
The second method is thermal transfer, which involves the transfer of
ink from a ribbon substrate onto the media with heat and pressure.
The ink is transferred to the label stock as it passes between the
printhead and the platen roller. To use this method, set the printer to
“transfer” before printing.
; Note: Ribbon should never be used with direct thermal stock.
Using this stock with a ribbon will result in poor quality print.
Complete the following steps to load ribbon:
n Unlatch and raise the printhead.
o Slide the ribbon roll onto the Ribbon Supply Hub with the
leader coming over the top of the roll. Ensure that the ribbon
roll is pushed back fully against the flange at the base of the
Ribbon Supply Hub.
p Thread the ribbon along the path as shown in Figure 3-6.
Figure 3-6 Ribbon Loading Path