Datamax PE - Manual (Page 43)

PE Series Operator’s Manual 33
QF!Pqujpot
(cont.)
Backfeed Cntrl Controls the timing associated with the backfeeding
of a presented label.
*20 ms after print 20 millisecond delay before printing the next label.
40 ms after print 40 millisecond delay before printing the next label.
60 ms after print 60 millisecond delay before printing the next label.
80 ms after print 80 millisecond delay before printing the next label.
99 ms after print 99 millisecond delay before printing the next label.
no backfeed Disables all backfeed motion.
before print Backfeeds without delay, upon next print cycle.
Ribbon Low Sets the output polarity of the applicator port pin #2
ribbon low signal.
*Active Low Signal goes low for ribbon low condition.
Active High Signal goes high for ribbon low condition.
Sjccpo!Mpx!Ejb
/
Allows user to select how much ribbon will remain
when a Low Ribbon message is displayed.
*20
Value range: 14-34
The value selected is the remaining diameter in
tenths of an inch.
Qsjoufs!Npefm
Instructs the printer of the mechanism’s configuration
for printhead zero dot orientation.
*Left Hand Right side label output.
*Right Hand Left side label output.
Dpvoufst
Read only check of the printer’s absolute values.
Absolute Values Given in inches; not resettable.
Ebuf0Ujnf
Allows the current date and time fields to be
changed.
Mbcfm!Pqujpot
Allows access to six label parameters.
Heat Setting Allows the selection of different heat settings.
Changes the "on time" of the printhead dots.
*10
Value range: 0-30
The higher value, the darker the print.