Datamax PE - Manual (Page 24)

PE Series Operator’s Manual 14
q Remove the J-Hook from the Ribbon Take-up Hub, ( as a
convenient option you may use an empty ribbon core to
rewind the spent ribbon, if using this method do not reinstall
the J-Hook).
r While holding the Ribbon Take-up Hub, rotate the J-Hook to
unlatch it.
s Raise the J-Hook away from the hub and place the end of the
ribbon over the take-up hub.
Figure 3-7 J-Hook
t Slide the J-Hook back into place as shown in Figure 3-7.
While holding the Ribbon Take-up Hub, rotate the J-Hook
until it latches. Turn the Ribbon Take-up Hub several times
to secure the ribbon.
u Lower the Head Lift Lever until the printhead is locked in the
down position.