Datamax PE User Manual
Page 46
PE Series Operator’s Manual
36
Dpnqbubcjmjuz
Three selections to control label positioning
Offset Bias
*220
110
Selects from two different Start of Print positions.
This command sets the point where printing starts,
relative to the Top-of-Form Adjust value. The
printer will feed from the Offset Bias and the Top-
of-Form Adjust value to begin printing.
Positioning
(PE 42 only)
Allows the selection of the column position
calculation based upon one of two different values.
*203 dpi
Exact column positioning.
200 dpi
Host CMDS-Ignore
This parameter instructs the firmware whether to
process the DPL commands for Offset Position
(
(stx>l>h)
ProdigyPlus Mode
This function sets the parameters so the printer will
emulate a Prodigy Plus printer. These parameters
are:
Offset Bias = 110
Positioning = 200DPI
Host Positioning = IGNORE
Conversion = Inches
Peel Position = .25" (1" if cutter is installed)
Pqfsbujpo
Sets three different operational functions.
Pause Mode
Causes the printer to pause between printing each
label.
*Disable
Enabled
The ‘Pause’ button must be pushed in order to print
the next label.
Feedback Mode
Causes the printer to feedback ASCII characters 30
and 31.
*Disable
Enable
The printer will return a 30 after each label is
printed and a 31 after each batch of labels.