Hanna Instruments HI 8000 Series - Manual (Page 56)

56
5.9.11 ERASE STATISTICS – S 61
Erase all: -
On overflow: Y
Daily at hour: 00:01
ERASE STATISTICS S61
With this panel it is possible to erase stored statistics pertaining to controller
function manually, on overflow, or at a certain time. Enter Y (yes) or N (no) next
to the selection or time for daily option.
Erase all
Manual command to erase statistics.
On overflow
Selecting this option sets the controller to erase statistics upon data over-
flow.
Daily at hour
Statistics can be erased daily by entering a specific time.
5.9.12 ERASE SETTINGS – S 62
Erase program: --
Erase all programs -
ERASE SETTINGS S62
With this panel it is possible to erase the settings of a specific program or all
programs. Erasing settings from an irrigation program provides a very useful
and easy mechanism to set one or all program parameters to null (default)
values. This operation will place a program in a NOT SET state meaning that it
is disabled. This function is only possible if a program is not active. Once the
command is accepted a delay period of approximately 3 seconds occurs. This
panel displays and allows the setting of the following parameters:
Erase program
Program number input.
Erase all programs
Selecting this option, Y (yes) or N (no), erases the settings for all nonactive
programs.
This operation will automatically reset the Fertigation Controller.