Hanna Instruments HI 8000 Series - Manual (Page 33)

33
Pause
The set pause time value for the indexed agitator of the selected program.
System clock
NOTE: The agitator’s working time values can be specified using panel S 45
(SET AGITATORS).
5.2.14 PROG LAST START – C 18
Prog 08 Filter --
Last start Manual
At 28-08 18:32 13:15
PROG LAST START C18
This panel displays the last start data for the indexed program, including the
filter-cleaning programs. There are 2 filter-cleaning programs, one for each
filter. The filter programs follow the indexed irrigation programs. For example, if
the Fertigation Controller is equipped with 10 irrigation programs, “Prog” num-
ber 11 and 12 will be designated for the two filter cleaning programs on the
above panel. In this case the first 10 program numbers will indicate the last start
data for the irrigation process. Programs 11 and 12 will indicate the last start
data for filter cleaning. The program number indexes this panel. This panel
contains the following information:
Program Number
Reflects the selected program (can be selected only inside panel C 03).
See Section 5.2.
Filter
Filter number
Last Start
The last start trigger for the indexed program (irrigation or filter cleaning).
At
The time of the last start for the indexed program.
System clock