FeiYu Tech FY-3ZT - Manual (Page 46)

GuiLin FeiYu Electronic Technology Co., Ltd.
GuiLin FeiYu Electronic Technology Co., Ltd http://www.feiyudz.cn E-mail: [email protected]
Page 45
please set ―ELE REV‖ in the ―Control Reverse‖ box. You should now see the correct servo
movement after ‗checking‘ the box.
RUDDER CHECK:
10. Holding the plane in your hands ―yaw the plane‖ from left to right. The rudder should give a
signal to counter the yaw motion as shown bleow:
11. If the rudder does not follow the correct movement, please set ―RUD REV‖ in the ―Control
Reverse‖ box. You should now see the correct servo movement after ‗checking‘ the box.
Throttle Detection:
12. Warning: It is recommended that you remove your prop or disable your motor while
performing these setup procedure.
13. Pleases refer to the throttle output at the servo display as shown to the right.
14. With your throttle at the lowest setting the number should read 1000. As your throttle up this
number should get larger.
Rotate right
Rudder moves to the left
Rotate left
Rudder moves to the right
FY-3ZT IN AUTO BALANCE MODE